Select Page: 1 member...
Member Information and Posts by WT
Topic: Sensor technologies.
from the Forum department...
T/C extension wires
Posted by d- on 3 March, 2013 - 1:14 pm
use of neutral extension wires in industrial temperature measurement
Topic: Application Questions and Problems
from the power generation department...
Generating electricity using household water pressure
Originally posted by Earl Smith on 21 March, 2008 - 11:46 pm
how can I generate 12 volts AC or DC using only household water pressure, and what is the smallest this generator can be? Can it be smaller than 120cc?
New Replies:
Thought this to be a moderated forum. Rather strange, hardly a useful subject for a technical forum...
Topic: Sensor technologies.
from the RTD's vs Thermocouples department...
Originally posted by Tom Jones on 15 March, 2011 - 2:47 am
Issues with RTD lead wires breaking. To share my experience and get others advice on RTD's V TC's.
New Replies:
re. Bob P. Comments Bob, what little data is available on sensor endurance is mostly in regard...
rtd's are quite sensitive to flow induced vibration. At a minimum you will see irreversible...
Originally posted by Phillip Won on 21 June, 2010 - 3:13 pm
The water level at IP drum in HRSG reached high-high peak during cold start-up due to sudden pressure drop and plant was tripped
New Replies:
the indicated water level is driven by the density and how your transmitters are installed. Cold...
Topic: Continuous process industries, DCS questions.
from the Instrumentation department...
RTD Thermowell Response Time
Originally posted by MSalem on 4 April, 2010 - 7:30 pm
Thermowell RTD response time calculation
New Replies:
last comment meant for a related thread, appologies...
The quick answer is that the thermal mass of the tip goes as sqr (Tip_new/Tip_old), so the time...
Certainly possible, and done routinely. The only issue are the details. The simulation that...
Topic: Engineering and workplace issues.
from the Forum department...
response time of RTD
Originally posted by Ayesha Nasser on 17 January, 2010 - 12:28 am
effect of response time of RTD with increase in thermowell diameter, especially in stepped type thermowell
New Replies:
Calculation on an air basis shows that at 8.4 m/s your first order response time is 18.8 seconds....
Topic: Engineering and workplace issues.
from the Forum department...
orifice sizing
Originally posted by Kuldeep on 30 March, 2010 - 7:06 am
Importance of velocity in Orifice sizing calculation
New Replies:
Piece of Cake! Good orifice metering based on installations that are hydraulically similar, ie....
Select Page: 1

Your use of this site is subject to the terms and conditions set forth under Legal Notices and the Privacy Policy. Please read those terms and conditions carefully. Subject to the rights expressly reserved to others under Legal Notices, the content of this site and the compilation thereof is © 1999-2014 Nerds in Control, LLC. All rights reserved.

Users of this site are benefiting from open source technologies, including PHP, MySQL and Apache. Be happy.

Q: How did you get into artificial intelligence?
A: Seemed logical -- I didn't have any real intelligence.
Advertise here
our advertisers
Help keep our servers running...
Patronize our advertisers!
Visit our Post Archive