Control

GE Fanuc Series 90 Micro

K

Thread Starter

K.S.Raju

GE Fanuc Series 90 Micro for controlling pneumatic and electrical controls. When I press any of these controls, the controls are not working. Green LED is glowing in input area of the PLC corresponding to that particular control, but no output LED is glowing. Kindly help, somebody.
 
P

peter

You must have a program loaded. PLC must be then in RUN mode. This is indicated by RUN light ON. Please check this. Then consult a person who wrote the program.
 
You must log in or register to reply here.
Thread starter Similar threads Forum Replies Date
X GE Fanuc Series 90-30 PLC using Proficy Machine Edition General Automation Chat 2
M GE-FANUC SERIES 90-50 PLC AND HORNER DNT250 SCANNER NOT COMMUNICATING WITH NEW DNET LIGHT TOWER Programmable Logic Controller - PLC 0
K Fanuc Series One Junior General Software Chat 4
P Modbus communication between GE Fanuc series 90-30 PLC & Bently nevada Modbus 2
C GE Fanuc Series 90 Micro - HSC and Pulse wave input Programmable Logic Controller - PLC 1
Similar threads
GE Fanuc Series 90-30 PLC using Proficy Machine Edition
GE-FANUC SERIES 90-50 PLC AND HORNER DNT250 SCANNER NOT COMMUNICATING WITH NEW DNET LIGHT TOWER
Fanuc Series One Junior
Modbus communication between GE Fanuc series 90-30 PLC & Bently nevada
GE Fanuc Series 90 Micro - HSC and Pulse wave input

You May Also Like

Top