S
During synchronization when the voltage and frequency of the system and source matches (which can be observed through parameters on the screen and can be adjusted according to the requirement for proper synchronization)we will close the breaker.
But as the phase angle is also very much important parameter which must be considered while synchronization how to observe it?
I think when the phase angle shows zero we can synchronize(I am not sure)..on the synchronization screen we have phase angle value..
my second doubt is while we are attempting synchronization in Auto if the synchroscope needle rotates in the ccw direction instead of cw...can we consider it as a reverse current??/
Kindly clarify above....your reply makes me more knowledgeable.
Surya
But as the phase angle is also very much important parameter which must be considered while synchronization how to observe it?
I think when the phase angle shows zero we can synchronize(I am not sure)..on the synchronization screen we have phase angle value..
my second doubt is while we are attempting synchronization in Auto if the synchroscope needle rotates in the ccw direction instead of cw...can we consider it as a reverse current??/
Kindly clarify above....your reply makes me more knowledgeable.
Surya