AVR prismic a30

  • Thread starter A man who want to learn
  • Start date
A

Thread Starter

A man who want to learn

Our avr prismic have been working switching leds 1 & 2 from the standby card since the day that was commissioned. I've been reading and now I'm not to sure that was the right operation mode. Is correct that led 2 always had to be on and led 1 had to be off unless an event occurs, isn't?
 
S

Sebastian Rebord

When the AVR is operating in main and the balance with the standby is OK, LED1 and LED2 have to flicker. If only 1 LED is on it means that you have not a match betwen Standby and Main.

Regards.
 
Top