S
I have a .pdf with all the pertinent info and a few pictures for clarity but if it is possible to connect to this message I did not see how. The short story is here:
Allen Bradley PLC SLC 5/04
On my laptop I'm running XP Pro SP3
RSLinx Classic Lite 2.59.02
RSLogix 500 6.30.00 (CPR 6)
In use the CPU is setup for comms on:
Channel 1 - DH+ @ 57.6K, Node Address 53 (Octal)
Channel 0 - Driver= DF1, Full Duplex 9600 N,8,1 CRC and the Ch0 USR info is= Driver= ASCII, 1200 N,8,1 No handshaking.
I have 3 cables:
USB-1747-CP3 (USB on one side, Serial connector on the other)
1747-UIC (USB on one side, Serial connector on the other)
HMI-CAB-C49-J (9pin mini-Din? {serial?} to DB-9.
You can reach me via email at [email protected] and I can forward a .pdf with good pictures of the cables etc. All help is appreciated!
-Sam
Allen Bradley PLC SLC 5/04
On my laptop I'm running XP Pro SP3
RSLinx Classic Lite 2.59.02
RSLogix 500 6.30.00 (CPR 6)
In use the CPU is setup for comms on:
Channel 1 - DH+ @ 57.6K, Node Address 53 (Octal)
Channel 0 - Driver= DF1, Full Duplex 9600 N,8,1 CRC and the Ch0 USR info is= Driver= ASCII, 1200 N,8,1 No handshaking.
I have 3 cables:
USB-1747-CP3 (USB on one side, Serial connector on the other)
1747-UIC (USB on one side, Serial connector on the other)
HMI-CAB-C49-J (9pin mini-Din? {serial?} to DB-9.
You can reach me via email at [email protected] and I can forward a .pdf with good pictures of the cables etc. All help is appreciated!
-Sam