M
I am looking for your help to solve this problem. I use IR Back-Scatter sensor to measure the suspended solid in sludge inline. However, I think the pressure in the line prevents it from getting the right measurement because when I did the calibration I tried 3 different concentration samples (static) and I can get the difference in mA and/or voltage reading but when I install the sensor in pipeline I cannot get the difference in reading so I presume it's the pressure problem.
So is there any solution in terms of sensor electronic board modification to handle the pressure or in terms of the pipeline to reduce the pressure like bypass or any other solution you suggest?
Thank you very much and I really looking forward to your advice.
Regards
maj
So is there any solution in terms of sensor electronic board modification to handle the pressure or in terms of the pipeline to reduce the pressure like bypass or any other solution you suggest?
Thank you very much and I really looking forward to your advice.
Regards
maj