Mitsubishi PLC and BACnet

G

Thread Starter

GaDawg

I am looking for a way to allow my Mitsubishi FX2N PLC to link to a BACnet network (and/or LonWorks). I have found plenty of protocol converters but either the serial protocol does not match or networking format is not compatible. Does anyone have experience with this or know where I might go to find a solution?

Thanks.
 
R

Richard Theron

Hi

Depending on the protocol interface that is loaded on the Mitsubishi PLC, http://www.fieldserver.com has a wealth of experience of connecting PLCs to BACnet interfaces. FieldServer supports five different BACnet interfaces.

Regards,

Richard
 
Top