Control.com

Prosoft modbus settings

Search Forums New Posts
S

Thread Starter

Sreeraj

Hi
Can anyone please tell how to set slave ID for Prosoft modbus module used along with SLC 5/03 to communicate with DCS using Rslogix500 or is there anyother software for setting this adress.
Thanking you
sreeraj
 
You must log in or register to reply here.
Thread starter Similar threads Forum Replies Date
Jose Antonio Problem with the configuration module Prosoft MVI56E-MNET Modbus TCP/IP Programmable Logic Controller - PLC 0
Z ControlLogix and Prosoft and Slave Modbus Communication Problem Modbus 0
I Modbus Comm between Totalflow XFC and Prosoft PLX31 Modbus 1
M ProSoft MVI56E-MNET Modbus Setup Modbus 0
J Limitation of Modbus/prosoft Modbus 3
Similar threads
Problem with the configuration module Prosoft MVI56E-MNET Modbus TCP/IP
ControlLogix and Prosoft and Slave Modbus Communication Problem
Modbus Comm between Totalflow XFC and Prosoft PLX31
ProSoft MVI56E-MNET Modbus Setup
Limitation of Modbus/prosoft

You May Also Like

Top