Control.com - Nerds in Control
from the Private department...
Speed Simulation
  |
Hi experts
I am new with that speed sensor. I want to simulate the speed signal plz guide me how can i simulate it? I have Fluke 741B and frequency counter as well.
The data of Speed probe is as under
60 pulses per revolution
Supply Voltage +9.5 to + 15 V
Power consumption 40 mA
Transducer Type MDg 14 Output signal +12 Volt depend on the supply voltage.
Range of working frequency 1 HZ to 30 Khz
The wiring diagram is attached with it.
Output is square wave.
http://i42.tinypic.com/34rgd3q.jpg
I want to ask how and what value of Volt and HZ i give to simulate 5500 RPM. Function generator have both options square wave and sine wave.
Which one i apply?
Regards
I am new with that speed sensor. I want to simulate the speed signal plz guide me how can i simulate it? I have Fluke 741B and frequency counter as well.
The data of Speed probe is as under
60 pulses per revolution
Supply Voltage +9.5 to + 15 V
Power consumption 40 mA
Transducer Type MDg 14 Output signal +12 Volt depend on the supply voltage.
Range of working frequency 1 HZ to 30 Khz
The wiring diagram is attached with it.
Output is square wave.
http://i42.tinypic.com/34rgd3q.jpg
I want to ask how and what value of Volt and HZ i give to simulate 5500 RPM. Function generator have both options square wave and sine wave.
Which one i apply?
Regards
Your use of this site is subject to the terms and conditions set forth under Legal Notices and the Privacy Policy. Please read those terms and conditions carefully. Subject to the rights expressly reserved to others under Legal Notices, the content of this site and the compilation thereof is © 1999-2013 Nerds in Control, LLC. All rights reserved.
Users of this site are benefiting from open source technologies, including PHP, MySQL and Apache. Be happy.
Fortune
If all else fails, immortality can always be assured by spectacular
error.
-- John Kenneth Galbraith
