AC800 with ET200

A

Thread Starter

antonio34

I have seen that there is a gsd for IM-153, ET200 interface to be connected from third party. I need to connect it to ABB AC800 and would appreciate if somebody has any experience on this?

Any problems or it works smoothly?
 
I haven't used the ET200 blocks, but have used profibus to several non ABB profibus devices including Siemens S5, Wago and others. In general, profibus works quite well with AC800M.

The process is fairly simple. Convert the GSD file into a hardware definition using the tool supplied with Control Builder and then import it into your project. You can find detailed instructions in the Control Builder M on-line help files.

Rob
www[.]lymac.co.nz
 
Top