Control

8003-DM Stepper motor driver connections

E

Thread Starter

ENKI

I need to control an actuator using a stepper motor controller which is linked to my computer through parallel port. The controller is an AMSI 8003-DM, which uses pins 2, 3, 8, 9, and 18. Someone get a mess with the connections and now I don't know where it connects each pin! someone made a bridge between H / F and GND on the 8003-DM controller. Can someone please help me? I can't get to the AMSI page. Reply to this post or to [email protected]
 
You must log in or register to reply here.
Thread starter Similar threads Forum Replies Date
zhenpingd45 Problem of oyostepper stepper motors connection Modbus 0
G FOC for stepper motors Motion Control 0
rockybhai Increase RPM of NEMA34 86HS9860A4 1.8 degree 6amp stepper motor Motion Control 3
annlee Looking for a Trap Door + Stepper motor with homing capabilities compatible with RPI General Automation Chat 2
A Software for AMSI 8003-DM General Software Chat 2
Similar threads
Problem of oyostepper stepper motors connection
FOC for stepper motors
Increase RPM of NEMA34 86HS9860A4 1.8 degree 6amp stepper motor
Looking for a Trap Door + Stepper motor with homing capabilities compatible with RPI
Software for AMSI 8003-DM

You May Also Like

Top