Control

Using 1747-sn

J

Thread Starter

Jeff

I am using the 1747-sn card trying to communicate to a remote rack with and 1747-abs card. I program for a full rack in rack 0 and left all the factory settings were they were. The dip switches in the abs are set for 230.4 k Baud and the rest are factory set. remote rack is 10 slot with abs being first spot then next two slots are open the I/o starts. I have noc on abs card and no light on sn card? Any help
 
You must log in or register to reply here.
Thread starter Similar threads Forum Replies Date
B Honeywell PHD RDI connection to ControlLogix's PLC's using factory Talk SE Programmable Logic Controller - PLC 0
K Using peak load to minimise emissions in normal ops (Frame 6s / Mark VI) Power Generation 3
LamijaZ Communication between ABB RTU530 and Siemens 7SJ62 using IEC 60870-5-103 protocol General Automation Chat 0
ducanhasd Control Servo mitsubishi using FB Motion Control 0
S AB SLC500 comms using 1747-KE Programmable Logic Controller - PLC 1
Similar threads
Honeywell PHD RDI connection to ControlLogix's PLC's using factory Talk SE
Using peak load to minimise emissions in normal ops (Frame 6s / Mark VI)
Communication between ABB RTU530 and Siemens 7SJ62 using IEC 60870-5-103 protocol
Control Servo mitsubishi using FB
AB SLC500 comms using 1747-KE

You May Also Like

Top