from the Forum department...
Bearing Temperatures
Sensor technologies. topic
Posted by Owais on 5 March, 2013 - 2:21 am
What are the good practices for installation of Machinery Bearing Temperature Elements (specially RTD) to prevent any spikes in the reading.

We have faced lots of machine trips due to bearing RTD's hunting, although wires in local JB are tightened properly.

Posted by David on 7 March, 2013 - 8:54 pm
Installing Instrumentation on Insulated Bearings _2001/1q01nurcombe.pdf

(remove any space characters the forum software inserts into the URL)

Posted by rishi on 21 March, 2013 - 5:53 am
There may be various reasons. Some of them are listed below

1. Improper grounding of system: The machine monitoring system is susceptible to malfunction due to improper grounding and this appears to be the biggest cause.

2. Oil in JB: Some time bearing oil may creep in JB and may cause the problem. though i have not faced such situations.

3. Lose wires.

But the biggest cause is improper grounding of the system

Your use of this site is subject to the terms and conditions set forth under Legal Notices and the Privacy Policy. Please read those terms and conditions carefully. Subject to the rights expressly reserved to others under Legal Notices, the content of this site and the compilation thereof is © 1999-2014 Nerds in Control, LLC. All rights reserved.

Users of this site are benefiting from open source technologies, including PHP, MySQL and Apache. Be happy.

"Protozoa are small, and bacteria are small, but viruses are smaller
than the both put together."
Advertise here
our advertisers
Help keep our servers running...
Patronize our advertisers!
Visit our Post Archive