Control

Torque Feedback not resetting in ALSPA CONTROCAD HMI

K

Thread Starter

KmnsKiran

While operating a MOV (desuperheating) from engineering station (controcad) by forcing its output open and close commands, its feedbacks are coming in HMI and Eng station. But close torque is not getting reset in HMI. What might be the problem? in MOV functional block torque feedback is coming when checking the continuity of torque switch, but in HMI it is not getting reset. It's ALSPA p320 system.
 
You must log in or register to reply here.
Thread starter Similar threads Forum Replies Date
S To control maximum torque of a motor with VFD General Automation Chat 5
M Electric motor torque control based on speed - Interaction/instability problems General Automation Chat 2
M Rotork actuator Torque sensor problem Instrumentation & Measurement 1
Andrew38 24v Wind Turbine Generator as Brushless DC Motor - BLDC High Torque Power Generation 0
S EXPLOTION OF TORQUE CONVERTER Instrumentation & Measurement 7
Similar threads
To control maximum torque of a motor with VFD
Electric motor torque control based on speed - Interaction/instability problems
Rotork actuator Torque sensor problem
24v Wind Turbine Generator as Brushless DC Motor - BLDC High Torque
EXPLOTION OF TORQUE CONVERTER

You May Also Like

Top