Cimplicity Access Error

R

Thread Starter

RandySki

After a power outage we are having trouble regaining communications between the PC(NT) and PLC(Series 90-30). We are receiving the message "\\NEWCOR1\USER_ACCESS can not be set because it is not configured".

Any ideas why we cannot re-power up?

Thank You,
[email protected]
 
Hi Randy,

Am I right to assume your project name is NEWCOR1? If that is the case, it seems to me that there is a script or a function running on your project that is looking to write a point with the name USER_ACCESS that does not exist in the project's point list and therefore, not configured.

I think this is a user configured point as Cimplicity's default points usually start with a $. If it's not a point that you are reading from the PLC, then it must be a virtual point. In that case it'd be just a matter of knowing what kind it is, if it's binary, real, integer, etc. and add a new point with that name.

Hope this helps
[email protected]
 
Top