S
One of our customers has reported a problem with one of the Mark-VI panels. There was a problem that S processor is getting hanged and giving Diagnostic alarms. So it was decided to replace the VCMI. After replacing the VCMI and downloading its firmware and configuration the processor was rebooted. Now the issue has become complicated, we are seeing RED INDICATION IN UCVE card. We tried to rectify it by replacing the UCVE and then built up PCODE and downloaded both RUNTIME and APPLICATION CODE to all three processors followed by rebooting complete MARK VI. But still UCVE in S showing the same RED INDICATION. Out of trying the same steps twice once it became healthy but again there is no repeatability of the healthiness status. Now the CONTROLLER STATE is reading CA and the IO STATE is 6A but still we have RED LED IN UCVE. Also we have diagnostics in VCMI
1) TOPOLOGY FILE/ CARD ID MISMATCH (FAULT CODE 56)
2) CARD ID/AUTO SLOT ID MISMATCH (FAULT CODE 55)
3) I/O CARDS 4/16/20/21 OFFLINE.
1) TOPOLOGY FILE/ CARD ID MISMATCH (FAULT CODE 56)
2) CARD ID/AUTO SLOT ID MISMATCH (FAULT CODE 55)
3) I/O CARDS 4/16/20/21 OFFLINE.