Control.com - Nerds in Control
Instructions for DISOMAT B plus
New Replies:
>my email address maniek290(@)interia.pl
>thanks
Check your mailbox....
my email address maniek290(@)interia.pl
thanks...
>ok, I'll wait:)
>thanks
Where to send?...
ok, I'll wait:)
thanks...
> I am looking a service manual (calibrate exactly password DISOAMAT B Plus) <
I will see...
Solution for display and alarm technology to monitor temperature.
New Replies:
dear kt,
thanks for your reply. can you tell me how can we configure as per my requirement....
Comparison among different makes of DCS used to control medium size of process
New Replies:
By J. Penagos on 16 December, 2009 - 11:56 pm -
Hi,
which DCS/PLC can support changes online in the logic??? Furthermore, I'm in the migration...
>Honeywell or Yokogawa
For what type of application?
In general if you are not making...
Honeywell or Yokogawa
...
How to create an audible alarm for a Graphic Window.
New Replies:
By RT on 16 December, 2009 - 10:33 pm -
You can try and do the same formula in a calcu and fire an %ANN and then use the %ann for the...
Flushing or cleaning a bubbler level system.
Help with hitachi inverter rs485 framing protocol
New Replies:
By Harvard on 16 December, 2009 - 6:58 pm -
RS485 is the physical layer, not a protocol. This site is intended for info on implementing Modbus...
I am working on ControlWave Micro RTU and facing problems regarding communication through RS232 port.
New Replies:
By scada4you on 16 December, 2009 - 3:30 pm -
You are making the right choice replacing it ASAP...
GE Mark VI TMR controller status R & S is boot and T in Failure
New Replies:
By Sha on 16 December, 2009 - 2:29 pm -
GE Mark VI TMR is used in GT and it is running with 120VDC power supply, The system was running...
You have not provided nearly enough information for anyone to make an educated response to your...
Is there anybody who has experience with the related protocol?
New Replies:
By BSR on 16 December, 2009 - 1:49 pm -
You can try to use TBox RTU by CSE-Semaphore company. It supports DLMS/COSEM protocol...
Implementing square root in the TRICON System
New Replies:
Dears thanks for your reply,
Now a new concern is which is better to implement the square root...
I tested the following in both Tristation 3.1 and 4.1. You did not state what version you have.
...
By Wassim Daoud on 14 December, 2009 - 5:49 pm -
Hello Kareem,
I hope you are using OPC. Because you can do that easily with it. If you do, all...
Anybody have service manual of X stream IR analyser CO2 measurement.
Coriolis Flow Meter plugs up after few minutes of operation.
New Replies:
By Tom Pugliese on 15 December, 2009 - 4:36 pm -
Try an Endress meter they have a full bore Promass I that would have no pres. drop...
What is the viscosity of your liquid? Try to heat it....
By FT on 13 December, 2009 - 6:46 pm -
Hi Bahawi,
Thanks for your reply. we cannot filter the process stream because it is not...
Flare Gas measurement ultrasonic / optical meters
New Replies:
By Brendan on 15 December, 2009 - 4:20 pm -
Nicolas,
Fluenta is the world leader in ultrasonic flare metering. Having more than 700 flare...
How Mark 3 Governor produces frequency droop.
New Replies:
Some droop systems use a measurement from the gas turbine related to the output power such as...
Need information on how to mask or adjust scan time for PER Alarms in Yokogawa CS3000 DCS
New Replies:
By wilson on 15 December, 2009 - 3:40 am -
PERR alarm occurs when both the limit switch acts on the field. kindly check the field limit...
In the pump level controller Datum U100 ABB we are getting the error message SYSTEM ERROR.
some conceptual documents such as cabling concept, earthing concept and so on would be helpful. do any body could send some info
Analogical entrance signs frozen, making unfeasible visualization and control of the turbine.
New Replies:
I work for a living, too. Please, call me CSA.
Thanks for the feedback! "Feedback is the...
Mister CSA,
I sought in it lists them and I found the solution for this problem in the post...
RTD signal interference from temp scanner power cable
New Replies:
By Roy Matson on 14 December, 2009 - 8:13 pm -
This is a very common problem but usually easily fixed.
Provide a Metal Oxide Varistor across the...
Online Operations with ABB 800xA
New Replies:
>> As part of the process, we make sure that we go through the difference report in detail,...
Hello Torulf!
Thanks for your answer.
Yes, you are right, Plantscape and HC900 are not...
By Torulf Wiberg on 13 December, 2009 - 7:52 am -
Evheniy,
The controllers behave very much the same with or without integration to 800xA.
...
By Rob on 12 December, 2009 - 8:52 am -
The Standalone AC800M compact controllers are absolutely identical to those integrated into 800xA....
Hello John,
thanks for your answer.
> As part of the process, we make sure that we go...
We have just commissioned three large 800xA systems and are in the process of cleaning up project...
Elimination static build up while cleaning control cabinets.
New Replies:
By giovanni on 14 December, 2009 - 9:18 am -
I use an Electronic Service Vacuum made by 3M. They are pricey but are designed for cleaning...
What type of cable can be used for Gas Detectors in Zone 0.
New Replies:
By Arun Kohli on 12 December, 2009 - 11:47 pm -
Dear Alagesh,
The word FRLS is used in India, is for "fire retardant low smoke", which...
Problem in network between CPU 313 and OP 17 DP. OP 17 DP is rebooting periodically.
New to Modbus want, to set up a slave with a 8051 microcontroller.
I am looking for a way to control a 4-20 ma analog input from 2 push buttons on a NEMA 7 panel.
New Replies:
By explosion proof, you mean your panel is a cast and bolted type such as Killark or Crouse-Hinds,...
we have bottom fired boiler and in every boiler 2 scanner is installed.
the furnace oil are snagged in the orifice head and also in the head of the scanner. so the scanner wont be able to work for a long time.
the furnace oil are snagged in the orifice head and also in the head of the scanner. so the scanner wont be able to work for a long time.
Need recommendations for data acquisition software for monitoring of flows temps etc for small plant
New Replies:
By Atindra Chandel on 11 December, 2009 - 11:05 am -
It is important to understand the kind of data acquisition device you will be using to interface...
Your use of this site is subject to the terms and conditions set forth under Legal Notices and the Privacy Policy. Please read those terms and conditions carefully. Subject to the rights expressly reserved to others under Legal Notices, the content of this site and the compilation thereof is © 1999-2010 Nerds in Control, LLC. All rights reserved.
Users of this site are benefiting from open source technologies, including PHP, MySQL and Apache. Be happy.
Fortune
"Why was I born with such contemporaries?"
-- Oscar Wilde
