Recent content by gustavo_marcelo

  1. G

    Start Command of Auxiliary Motors of Gas Turbines

    As usual CSA is there to assist..
  2. G

    Simulator for GE Mark VI

    :) :) I mean without the ST installed, can we use it? Sorry for the confusion. If it requires ST, then cant use it at my workstation.
  3. G

    Simulator for GE Mark VI

    How to use it actually?
  4. G

    VAR Control on Siemens SGT5-4000F

    Something on the machine and control. Can email at [email protected] >>I'm looking for some doc for SGT 4000 or 8000. >Specify which system DOC u need, may be I can find.
  5. G

    VAR Control on Siemens SGT5-4000F

    Hi Tony. I’m lookin for some doc for SGT 4000 or 8000.
  6. G

    Min Value Gate Operation

    This question sounds silly but here it goes. Still I want to know. Why do we select the lowest?
  7. G

    GE Speed Protection

    Hi CSA, How does the over frequency been coordinated with over speed? OS is in rpm, and OF is in Hz, but both related to each other. Who supposed to trigger first?
  8. G

    Simulator for GE Mark VI

    How to get the simumator?
  9. G

    Power Plant Generator Control

    No worry.It is a good explaination indeed. A bonus to the original poster.
  10. G

    Power Plant Generator Control

    "So, the generator is either in Voltage control (where the operator has to manually adjust the excitation to maintain the desired V Ar (MVAr) or Power Factor setpoint)" Quoting from the reply by CSA, 1.Is the mode above a manual mode? I thought if we were in the mode, it will automatically...
  11. G

    Paralleling Generators

    If the diesel engines are all connected to a grid and one engine had been operated with increase fuel, that engine will be exporting power to the grid. The other engines more or less maintain the same power.
  12. G

    VAR Control on Siemens SGT5-4000F

    Hi, Actually I am looking for some docs wrt to Siemens GT. Mind to email [email protected]?
  13. G

    Mark VIe Controller Turbine Block Library

    Hi, I do not have access to the Toolbox hence I could not read the details of the block ( restricted). I do have the logic tho...and found the rung for modes, etc. built do not have the details of the block except seeing the ladder.. Anybody can help?
  14. G

    Mark6e (MK5 migration) Exhaust Thermocouples Read Low

    I do not have anything to comment, but I do notice CSA is very knowledgeable especially things related to GE. Wish I can be an expert in GT one day.
  15. G

    Generator VAr vs PF control

    >You seem to have an islanded system at your site, that can >be used to gather some data when it separates from the grid. >AND, you seem to have some modeling capability, as well? Yes CSA, we can operate both.Yes, I did some modelling, but for this case I only used a generic model and...
See more
Top