Recent content by loly

Thanks for your response Kindly clarify where I need to implement the above-mentioned settings...

Greetings of the day! I use the General electric, MDS SD9 radio transceiver module for communication from the remote station (offshore) to the control room. Setup: 1st MDS SD9 radio connected to Camera's DVR via Ethernet port available in both modules. And in 2nd MDS SD9 radio is connected to a...

I need to know the PLC-to-PLC communication. I referred to your Telepace Studio training manual (MSTR block). We are using two Scadapack's for this demo operation in telepace studio software. One is scadapack357 - In this, we created the sample program by using one coil and one input register...

What kind of cable I should use for communication between LAN port SP357 and SP32 (PLC to PLC)? (Cross or straight). Kindly guide me. protocol - Modbus TCP/IP

I need to know the PLC-to-PLC communication. I referred to your Telepace Studio training manual (MSTR block). We are using two Scadapack's for this demo operation in telepace studio software. One is scadapack357 - In this, we created the sample program by using one coil and one input register...

Here we used the Com2(RS232) port is configured for both Scadapack. Protocol - Modbus RTU

Hai All, I need technical support regarding Wonderware Intouch. How to monitor the radio communication status in Wonderware? Actually, the receiver side of the radio generates 0-5v in Pin 5 (Analogue RSSI) depending on the communication strength. We need to show the status of the radio in...