Recent content by Mauricio Marquez

Hi wtf? thanks for your reply. What I should mention is that if there is a flow, the liquid fuel pressure reaches the filters in the GT with 6 bar, and goes through the on-off valve (I don't remember the device name), then it recirculates through the high pressure pump. and through the control...

Dear Hamsterking, you hit the piñata. As you said, I did write the signal to SITE.ASG, so I deleted it, as well as deleted the COPY block from the sequence along with DTKLT_AUX. I ran mk5make, and the duplicate signal problem no longer appeared, I continued with the usual process, and finally...

Hi Hamsterking, thanks for your reply. I think I did wrote the point name in SITE.ASG... so, if I write the signal there and in IO.ASG, is it likely to be the cause of the duplicate signal?. I wrote the signal in SITE.ASG because I have seen some TAs do it (I think in the flowchart that I...

Hahahaha, I believe you, trust me. I have worked with control engineers from MHI (now MHPS)...and they wore toe socks every day in their office, many with hilarious designs... and as you say, they were on another cognitive level for me (well, Japanese after all).

Dear CSA, thank you for your concern and for your instructions. I will tell you the whole problem. The national energy coordinator requires to know the levels of the diesel tanks of all the machines that use, well, diesel fuel to run. I was asked to add the tank level signal to the MKV of our...

Hi Hamsterking, thanks for the clarification about the IO CFG FAILED message, in any case it seems to me that it is very counterproductive that the display shows that message when in reality, supposedly, there are no problems with the configuration, but since you assure me, I will not put more...

Hi CSA, thanks for the reply. Ok I understand, Ill check for the timestamps. Mmm you´re right, I wrote the signal in the C core in IO.CFG, but modified the TCQA card in IO configurator (actually, it seems is the only analog card that the IO configurator enables me to modify). I will check and...

Hi James, thank for your reply. Emmm no, I did´nt know I had to create a new UNITDATA.DAT file, how do I do that? Neither in the manual nor in the flowchart does it tell me that I should do that for the AI. I´m uploading pics of the aforementioned flowchart. THanks!

CSA, good morning. I finally found the problem (and the solution), I am a bit ashamed to write it, but I will do it in order to be aware of the error in case the same thing happens to another person. After ruling out the voltage problem towards the 20FG-1 for what you explain in your previous...

Dear CSA, I am very sorry, I made another mistake giving you specific information, the turbine has a 20VG-1 solenoid valve (I made a mistake out of ignorance), after your second message I found that SV and the goose neck vent outside the gas compartment. I thought you were talking about the...

First of all, thank you very much for answering, I have read many of your threads and I have learned a lot from you and from this wonderful page. Continuing with the topic, I think I explained badly and I lack information to deliver ... After the failed ignition of which I speak, I did test the...