Recent content by neurox

Sure, the ambient temperature is relatively stable (in range 31 - 32 Celsius). The CPD before is at 9.04 bar, but now only 8.9 bar and in the mid day some times reach 8.75 bar For offline wash, it's been a long time since the last time we did that, may be 10 Years ago, but we just conduct rotor...

Dear All, Hopefully there is still a response in this thread. I have some question related with CPD pressure. I have Frame 6 gas turbine with turboline control system, which run in part load or Pre-select Mode (not based load, we set MW at certain value) with gas fuel. Currently, I have...

many thanks CSA for your brief answer, (y)

Thanks a lot CSA for your brief explanation, Honestly, I'm new in gas turbine and my background is chemical engineering but I want to learn about gas turbine and its control. In practical, how often we need to do offline cleaning for axial compressor with water wash? during gas turbine...

Many Thanks CSA for your response, First, for vibration, If I'm not wrong, the cooling in support leg is provided to avoid any thermal expansion at the support leg. I suspect, when one of support leg has cooling water leak, it's impact to un-balance thermal expansion between two support leg and...

Hopefully, there are a response in this old thread. I've GE Frame 6 with Turboline controller, I've encounter CW Leak at one of two turbine support leg, after this leak happened I found that Vibration BB1 and BB2 are slightly increase (1.8x to 2 - 3.4x mm/s) and CPD (compressor discharge...