PV800 Numeric Entry Dialog

Hello all and thanks for reading my question.

I was recently handed a small project using a CompactLogix and a PV800 HMI (2711R-T4T).
I was able to create the screens with all the desired objects and download to the HMI from CCW software.

Now the issue: I have a number of objects on the screens that are intended for operators to enter process variable settings. When one of these objects is pressed, an extremely small value entry dialog pops up. Each of the buttons on this dialog are maybe .125" square. Absolutely unusable in a factory setting.

Does anyone have any suggestions or work-around for this lackluster design?
 

Attachments

Having a history of panelviews and Rockwell, and having experience of the early '800's it would not surprise me to find they have reduced the 7inch down to 4inch without changing proportions of the 'popups'.

Whoever purchased this PV800 HMI (2711R-T4T) will have Technical support, and would raise the point as you have to us; since I suspect this will be a firmware issue.

https://www.rockwellautomation.com/en-gb/products/details.2711R-T4T.html

Good Luck and let us know the outcome !
 
Top