M
We're running the latest version of RSLogix5 English, 5.00.01, and use 5/40B processors. If we make an on-line change to an analog scaling value, accept the edit, then download the changes, sometimes the processor crashes. We're at the point were we can no longer do on-line analog work while our mill is running for fear of crashing the process. The crashes also happened with previous RSLogix 5 version 4.10.01.
We used to use Rockwell's Wintelligent Logic 5 software v.3.23.00 and still have it on one pc. We can use it to do on-line analog work till the cows come home without a problem. It's only since we switched to RSLogix5 that these crashes have been happening.
Has anyone else out there experienced the same problem? Is there a fix?
We used to use Rockwell's Wintelligent Logic 5 software v.3.23.00 and still have it on one pc. We can use it to do on-line analog work till the cows come home without a problem. It's only since we switched to RSLogix5 that these crashes have been happening.
Has anyone else out there experienced the same problem? Is there a fix?