G
Hello
My company uses ABB ACS800 inverter in which I need to open a relay on X25 in the drive panel.
The relay is on X25 where the power (+24V) is connected to port 2, and the relay should close the circuit between port 2 to 3.
the communication is Modbus over Ethernet. I have the RETA-02 module.
what would be the address and the parameter sent in order to activate this relay?
Thanks
Gil
My company uses ABB ACS800 inverter in which I need to open a relay on X25 in the drive panel.
The relay is on X25 where the power (+24V) is connected to port 2, and the relay should close the circuit between port 2 to 3.
the communication is Modbus over Ethernet. I have the RETA-02 module.
what would be the address and the parameter sent in order to activate this relay?
Thanks
Gil