A
Hi,
We are using ABB RTU 560A for a power plant control.
This problem happened when RTU recieves more than one Analog setpoint command (IEC 104- type 48), here the RTU execute the first one only.
Refer to ABB manual, I found a such case.
If I get the manual point, the question is:
1. Is this problem found in ABB RTU560 only?
2. If its not, how to overcome it?
Regards
We are using ABB RTU 560A for a power plant control.
This problem happened when RTU recieves more than one Analog setpoint command (IEC 104- type 48), here the RTU execute the first one only.
Refer to ABB manual, I found a such case.
If I get the manual point, the question is:
1. Is this problem found in ABB RTU560 only?
2. If its not, how to overcome it?
Regards