about the communication between messung nexgen2000 & cimplicity

S

Thread Starter

suman

I am new to messung PLc's, anybody knows how to comunicate messung nexgen 200 plc with GE Fanuc cimplicity scada, meanwhile i like to communicate without using modbus protocol.
 
D

Devdatta Hambardikar

Dear Suman,
We supported Modbus protocol because it is one of the de-facto standard way of communicating with wide variety of third party HMI and SCADA. However, Nexgen2000 is not limited to Modbus.

Messung Nexgen2000 PLC is designed using IEC standard programming platform. This allows you to develope your own protocol in PLC. There are lots of instructions (FUN/FB) supporting third party protocol communication in this PLC. You can write program to convert this PLC as Master or as slave based on your expecations.

A project template is also available from Messung using IEC Languages ST and SFC to ease the protocol writing process.


You may log-in to Messung support site www.messungautomation.com/support and detail-out your expectations.

Devdatta Hambardikar, Messung Systems
 
Top