Control

AC-DC rectification with simulink

S

Thread Starter

simulinkfan123

1678652619340.png
1678652721240.png
Designed a rectifier to change 300V AC to DC and a converter to achieve output voltage of 100V. When simulating, I receive this error message. Is anyone able to spot a mistake?
 
You must log in or register to reply here.
Thread starter Similar threads Forum Replies Date
T To verify state estimator(observer) using Simulink. Computing 0
H Using a PID controller in simulink to simulate shift jerk in dual clutch transmission General Communications Chat 1
cadenabaldovin Field oriented control (FOC) project with Simulink Electrical Engineering 3
A Mark-V Ground Fault Rectification General Automation Chat 0
A Turbine Ground Fault Rectification General Software Chat 16
Similar threads
To verify state estimator(observer) using Simulink.
Using a PID controller in simulink to simulate shift jerk in dual clutch transmission
Field oriented control (FOC) project with Simulink
Mark-V Ground Fault Rectification
Turbine Ground Fault Rectification

You May Also Like

Top