J
We have a mixer driven by 125HP motor being controlled by ACS850 through PLC.
We encountered motor stop in the middle of our mixing operation which is not supposed to be... Its normal operation only stops when the material reaches the 110-degree celcius set value, but the motor just stop even if the temperature is still low @ 80-degree C to be specific and there's no alarm on the ACS850 drive even in our SCADA/PLC control.
Do you have any opinion about the cause? Thanks
We encountered motor stop in the middle of our mixing operation which is not supposed to be... Its normal operation only stops when the material reaches the 110-degree celcius set value, but the motor just stop even if the temperature is still low @ 80-degree C to be specific and there's no alarm on the ACS850 drive even in our SCADA/PLC control.
Do you have any opinion about the cause? Thanks