P
Hi All,
I am having a look at software to provide or use in developing an automated Fault Detection and Diagnosis (FDD) system. Does anyone have experience with the use of this type of facility either in industrial automation or building automation.
I am looking at CLIPS as a possible componenet of the FDD system. CLIPS provides an expert system shell for rule based programming. Does anyone
have experience in use of this software for FDD.
I have also come across Gensym's G2 Diagnostic Assistant which looks very sophisticated but probably expensive. Is anyone using this?
Any comments or suggestions would be appreciated.
Regards
Peter Whalley
Managing Director
Magenta Communications Pty Ltd
121 King Street,
Melbourne, VIC 3000
Australia.
e-mail: [email protected]
I am having a look at software to provide or use in developing an automated Fault Detection and Diagnosis (FDD) system. Does anyone have experience with the use of this type of facility either in industrial automation or building automation.
I am looking at CLIPS as a possible componenet of the FDD system. CLIPS provides an expert system shell for rule based programming. Does anyone
have experience in use of this software for FDD.
I have also come across Gensym's G2 Diagnostic Assistant which looks very sophisticated but probably expensive. Is anyone using this?
Any comments or suggestions would be appreciated.
Regards
Peter Whalley
Managing Director
Magenta Communications Pty Ltd
121 King Street,
Melbourne, VIC 3000
Australia.
e-mail: [email protected]