Automatic Valve Control by Sensing the Water Level


Thread Starter

liya kj

in our farm there is a huge tank. from there we supply water to four water tanks placed in four locations. water is supplied through four different pipes which is controlled by manually using valves placed in each pipe. we have to control the opening and closing of these valves automatically according to the water levels in each tank without overflowing.

could you please suggest any solution to handle this problem?



Not sure if this would help.

I make mechanical Delay Valves that go in tanks. When a tank is full, the Delay Valve will keep shut until the water level in the tank drops about 4 inches. The Delay Valve will then open fully and fill the tank at full bore to the upper level. I make most sizes of valves. You can contact me below.

Hope I can help, Dennis.