Control

Barrier Programming for P & F model KFD2-UT2-Ex1-1

M

Thread Starter

Manas

In our control room,P&F barrier with model no. KFD2-UT2-Ex1-1 is coming with a programming port. What is the requirement of this programming port? Can anybody tell me specific application? How to program?
 
R

ROBERT WAGNER

P&F has a free programming software called PactWare which is used to access these units.

A special programming cable is also required.
 
T

Tanmay

you need PACTware tool..

this barrier is meant for both RTD & TC..so you need to program that accordingly to feed type of input, sensor type, ranges, etc.
 
You must log in or register to reply here.
Thread starter Similar threads Forum Replies Date
S Barrier on standard analogue input PLC card Instrumentation & Measurement 2
P II (1) G Ex [ia Ga ] IIC (Ga) Associated Apparatus (Barrier) ATEX/ IEC Marking Instrumentation & Measurement 0
S Micromotion Flowmeter - Barrier Requirement Instrumentation & Measurement 0
J Am I correct in understanding that if equipment is certified as "mb," there is no need to install an isolation barrier? Electrical Engineering 4
S Zone 2 - I.S Barrier Safety 7
Similar threads
Barrier on standard analogue input PLC card
II (1) G Ex [ia Ga ] IIC (Ga) Associated Apparatus (Barrier) ATEX/ IEC Marking
Micromotion Flowmeter - Barrier Requirement
Am I correct in understanding that if equipment is certified as "mb," there is no need to install an isolation barrier?
Zone 2 - I.S Barrier

You May Also Like

Top