Control

Beckhoff Counter terminal KL1051

P

Thread Starter

pravin

Hi All,
I connected a beckhoff counter terminal to the Siemens 315DP PLC via a bus coupler BK3120. Now I want to check whether it is correct or not. I want to know what are the steps I have to take to see whether the counter terminal is working properly or not. I know that thereis mapping of 5 input and 5 output bytes out of which the four bytes are for the data and one byte for the control/status. But when at the input terminal(Pulse IN) a pulse signal is given then there is nothing at the output terminal. Please tell me what can go wrong in this configuration.
 
D

Dobrowolski, Jacek

Hi,

First of all, you mean KL1501, don't you ? Did you enable those outputs in the control byte of the terminal ?

Regards,

Jacek Dobrowolski, M. Sc. E. Eng.
Software Eng.
 
You must log in or register to reply here.
Thread starter Similar threads Forum Replies Date
B After updating the Nuget packages in Beckhoff Twincat of the projects, an error message occurs General Software Chat 0
S Beckhoff TwinCAT on PC with Intel-lan as a Ethercat Master General Software Chat 0
D Beckhoff CX5020 PLC program not work Programmable Logic Controller - PLC 1
D Twincat 2 - Download program to Beckhoff CX-90xx shown error Programmable Logic Controller - PLC 0
T Beckhoff Counter terminal KL1051 Problem Programmable Logic Controller - PLC 1
Similar threads
After updating the Nuget packages in Beckhoff Twincat of the projects, an error message occurs
Beckhoff TwinCAT on PC with Intel-lan as a Ethercat Master
Beckhoff CX5020 PLC program not work
Twincat 2 - Download program to Beckhoff CX-90xx shown error
Beckhoff Counter terminal KL1051 Problem

You May Also Like

Top