Control

CAMMING USING SINAMICS - CFC

A

Thread Starter

AVINASH

hello friends,

I want to do camming in sinamics s120 using CFC.

There is a block call as "software cam controller" in CFC but i dont know how to use this block. i also go through its help but didn't understand. Is it possible to do cam in sinamics? if yes then how can i do this?

 
You must log in or register to reply here.
Thread starter Similar threads Forum Replies Date
B Honeywell PHD RDI connection to ControlLogix's PLC's using factory Talk SE Programmable Logic Controller - PLC 0
K Using peak load to minimise emissions in normal ops (Frame 6s / Mark VI) Power Generation 3
LamijaZ Communication between ABB RTU530 and Siemens 7SJ62 using IEC 60870-5-103 protocol General Automation Chat 0
ducanhasd Control Servo mitsubishi using FB Motion Control 0
G Retrieve engine data via ComAp using Modbus RTU General Communications Chat 0
Similar threads
Honeywell PHD RDI connection to ControlLogix's PLC's using factory Talk SE
Using peak load to minimise emissions in normal ops (Frame 6s / Mark VI)
Communication between ABB RTU530 and Siemens 7SJ62 using IEC 60870-5-103 protocol
Control Servo mitsubishi using FB
Retrieve engine data via ComAp using Modbus RTU

You May Also Like

Top