Control

Can't send hex code from &H80 to &HFF over RS232 VB6 or VB.net

A

Thread Starter

allenFok

I have an industrial equipment that it is only accept the hex data. Once I send a hex value greater than &H80 the equipment shown &H3F. I'm very appreciate anybody can help me.
 
You must log in or register to reply here.
Thread starter Similar threads Forum Replies Date
A rslogix 5000 8th edition too old can't open an offline copy of the program because of error message "source not available" General Automation Chat 3
Shauni LCU 6 can't go online on CBM Distributed Control Systems - DCS 0
V I can't discretize a PIPD controller General Automation Chat 12
V PID design of a BLDC motor control can't be completed using Ziegler-Nichols because the slope doesn't match with wath is seen on the step response General Automation Chat 6
Taki27 Turbine Ge frame 5 can't end startup sequence Power Generation 23
Similar threads
rslogix 5000 8th edition too old can't open an offline copy of the program because of error message "source not available"
LCU 6 can't go online on CBM
I can't discretize a PIPD controller
PID design of a BLDC motor control can't be completed using Ziegler-Nichols because the slope doesn't match with wath is seen on the step response
Turbine Ge frame 5 can't end startup sequence

You May Also Like

Top