Control

Carriers "Carrier Comfort Network" (CCN) protocol

S

Thread Starter

Sandeep Shroff

Hello List Members

Has any body worked on Carriers " Carrier Comfort Network" (CCN) protocol.

Please guide me where could I find more information about this protocol for driver development.

Thanking you in anticipation

Sandeep Shroff
___________________________________
Sandeep Shroff
Sr. Consultant=20
Remote & Embedded Technologies
rapidEffect (P) Ltd. 25, Napier Road, Pune 411001, India
Tel./Fax. +91-20-6363250
www.rapideffect.com
 
J

Jorgemahieu

Hi
You may use Network Service Tools or Building Supervisor for acces Carrier Comfort Network in PLC´s CCN 1600 and 6400.Adding this,you may
use RS-232 to RS-485(two wires) converter and a ¨software acces key´ that sells only CARRIER with the software.I beg your pardon,but my
english is very bad.If you want,contact me at [email protected]
Bye
Jorge Mahieu
Argentina
 
You must log in or register to reply here.
Thread starter Similar threads Forum Replies Date
chathurais GE Fanuc 90-30 GNIU and IO carriers fault Programmable Logic Controller - PLC 0
tanld Power Line Carrier used to Detect Phase of Branch in Low Voltage (400-220V) Electrical Engineering 4
N Wiring for 1 Phase 460 Volt Evaporator Motor (Carrier Transicold) Motion Control 4
D Drive PWM/Carrier Frequency Question Motion Control 2
M Transmitting a Digital Signal without an Analog Carrier Signal? General Communications Chat 2
Similar threads
GE Fanuc 90-30 GNIU and IO carriers fault
Power Line Carrier used to Detect Phase of Branch in Low Voltage (400-220V)
Wiring for 1 Phase 460 Volt Evaporator Motor (Carrier Transicold)
Drive PWM/Carrier Frequency Question
Transmitting a Digital Signal without an Analog Carrier Signal?

You May Also Like

Top