Control

CC-Link Programming Using C#

J

Thread Starter

jreyes

Hi guys.
I've been looking for posts about programming CC-Link using computer instead of PLC. I am looking at IAI motor (gripper) with PCON-C controller, but instead of PIO, I will use CC-Link.

Any inputs will be much appreciated.
 
You must log in or register to reply here.
Thread starter Similar threads Forum Replies Date
waqasbm Emerson Ovation Ethernet Link Controller ELC in redundant confuguration Distributed Control Systems - DCS 0
T Sniffing Profibus Communication Link General Automation Chat 3
T mark V "I" work station does not see in stage link c-processor Human Machine Interface - HMI 0
D Trying to setup a Profibus link from one slave to two masters Motion Control 5
T Link for PLC2 Programming Software Programmable Logic Controller - PLC 1
Similar threads
Emerson Ovation Ethernet Link Controller ELC in redundant confuguration
Sniffing Profibus Communication Link
mark V "I" work station does not see in stage link c-processor
Trying to setup a Profibus link from one slave to two masters
Link for PLC2 Programming Software

You May Also Like

Top