Hello,

I do have Advantech PCI 1240U in PC and its connected through adam connection board with Omron R7 servos. I do have 3 for now but I need 4 axis for my setup. Is there any suggestions for my setup? and does does any software can handle this setup?

Does anyone can suggest what software can understand Advantech motion board and does drivers fit? Advantech PCI 1240U has 4 axis connection option and its running on XP. I need good software for handling this hardware.

Thanks and regards

 

Warning this post is about a product we sell.

Are you looking for something to stimulate your drives so you can run your motion controller without your equipment? We have a device that may help with that. This is our servo simulator.

http://www.theautomationstore.com/servo-axis-simulator-usb-for-motion-controllers-and-cncs/