Communicating between ML 1100 and Danfoss FC302 drive

D

Thread Starter

Dave

Hi all,

I am upgrading the controls on a tablet press and want to communicate to a Danfoss FC302 drive using the channel 0 on the AB Micrologix 1100 (the ethernet port is connected to a panelview plus). I was told by danfoss that the drive is compatible with modbus and could use modbus to talk to the drive However the drive only has the FC protocol or standard bus available via the rs 485 comms and the info on their site is a bit vague. Has anyone done anything similar to this as I don't think this is possible? If possible or if anyone knows of another way and can explain it to me or has some sample code it would be greatly appreciated.

Thanks in advance.
 
Top