Communicating to Bailey DCS INFI90 network


Thread Starter

Michael Sing

I need to communicate directly to a Bailey DCS INFI90 network from my PLC network. I need to go through the Bailey CIU module. Ideally I would like to use Modbus TCPIP and bridge to the INFI90 network. Is anyone aware of a bridging device which will allow this. Cheers Michael Sing
What PLCs are you using? You could use the Bailey GPI (General Purpose Interface) to communicate, using Modbus, to one PLC and that PLC can bridge to the Modbus TCPIP network. Corey Corey White Graduate Student Instrumentation Control and Automation Centre Faculty of Engineering and Applied Science Memorial University of Newfoundland