Control

Communicating to Bailey DCS INFI90 network

M

Thread Starter

Michael Sing

I need to communicate directly to a Bailey DCS INFI90 network from my PLC network. I need to go through the Bailey CIU module. Ideally I would like to use Modbus TCPIP and bridge to the INFI90 network. Is anyone aware of a bridging device which will allow this. Cheers Michael Sing
 
C

Corey White

What PLCs are you using? You could use the Bailey GPI (General Purpose Interface) to communicate, using Modbus, to one PLC and that PLC can bridge to the Modbus TCPIP network. Corey Corey White Graduate Student Instrumentation Control and Automation Centre Faculty of Engineering and Applied Science Memorial University of Newfoundland
 
You must log in or register to reply here.
Thread starter Similar threads Forum Replies Date
A Prosoft card communicating with 2 seconds delay in L63 processor Programmable Logic Controller - PLC 0
E Communicating with Device over Modbus RS 485 and TCP/IP Modbus 1
S Hart 475 not Communicating Fisher DVC 2000 General Communications Chat 4
M Problem Communicating with RTU560 Programmable Logic Controller - PLC 0
S Communicating with STN Atlas Geamar 120ISL/Lyngsoe Marine Programmable Logic Controller - PLC 2
Similar threads
Prosoft card communicating with 2 seconds delay in L63 processor
Communicating with Device over Modbus RS 485 and TCP/IP
Hart 475 not Communicating Fisher DVC 2000
Problem Communicating with RTU560
Communicating with STN Atlas Geamar 120ISL/Lyngsoe Marine

You May Also Like

Top