L
I need to communicate with an old Mitsubishi F1 PLC.
I have some experience working with the FX series, but I have no experience or documentation of the F1 series.
I will appreciate if someone could send me the following information:
1) The default serial port configuration (baud, number of data bits and parity)
2) The frame format for the following commands
Send byte(s)
Read byte(s)
Force device
3) Address memory map, namelly the addresses of the following devices/registers
M230..M277
D770..D777
Thank you very much,
Lino Marques
[email protected]
I have some experience working with the FX series, but I have no experience or documentation of the F1 series.
I will appreciate if someone could send me the following information:
1) The default serial port configuration (baud, number of data bits and parity)
2) The frame format for the following commands
Send byte(s)
Read byte(s)
Force device
3) Address memory map, namelly the addresses of the following devices/registers
M230..M277
D770..D777
Thank you very much,
Lino Marques
[email protected]