Communications with Keltronics Motor Controller


Thread Starter

Mr. Nasser

I was wondering if you can help me. My company has Keltronics K095 Motor Controller for our ESP oil wells.

The K095 communicating well with our CAC 6500-EFM RTU but if I tried to connect it (I mean the K095) directly to the Modbus Scanning software it's not communicating even when we connect the DCD from the K095 to RTS in RTU.

The communication parameters was as follows:

Remote Address: 1
Baud Rate: 1200
Parity: None
Data: 8
Stop: 1
Type: Modbus RTU

Do you think I should use Keltronics as the Modbus type or what? Please Help.