Control

config I/O for Omron CPM2* in cx-programmer

S

Thread Starter

Sally

I am new to cx-programmer. Does any one know how to config I/O for omron CPM2* in cx-programmer?

There is no I/O table section for COM2*. The CPM manual said that the I/O area is in HRxxxx, but I can't use that area in cx-programmer for some reason.

Thanks.
 
A

Anonymous

I/O addressing is fixed in this PLC. Inputs start at channel "0" and outputs at channel "10".

Check the manual.
 
You must log in or register to reply here.
Thread starter Similar threads Forum Replies Date
Thanakorn Auma Actuator, fault by "IE remote Prm config" (PRM_604 code) Instrumentation & Measurement 1
A Compressor Anti Surge Config from CCC General Software Chat 9
T Replaced VSVO card on Simplex MK6 generates alarm message after config download Power Generation 6
C Config 1-5V DC Transmitter to work as 0-5V Dc on GE MARK V Power Generation 13
K XM-220 Module via DeviceNet Config Programmable Logic Controller - PLC 2
Similar threads
Auma Actuator, fault by "IE remote Prm config" (PRM_604 code)
Compressor Anti Surge Config from CCC
Replaced VSVO card on Simplex MK6 generates alarm message after config download
Config 1-5V DC Transmitter to work as 0-5V Dc on GE MARK V
XM-220 Module via DeviceNet Config

You May Also Like

Top