Control

Configuring Simatic ET200s and IEC 60870-5-104

  • Thread starter Ahmadreza Tarakameh
  • Start date
A

Thread Starter

Ahmadreza Tarakameh

I have done a telecontrol project with Simatic ET200s and wincc HMI. our client is going to gather the data of various RTU in central control room with Hige-leit HMI through IEC-104 and asked me to bring them the IEC tag and master slave addresses. how could I configure the ET200s?
 
You must log in or register to reply here.
Thread starter Similar threads Forum Replies Date
Ankur1007 Configuring Analog I/O board and I/O packs of Mark Vie control system Power Generation 2
S Configuring SDB Utility General Automation Chat 0
R Configuring S7-1200 IO-Link Master Module (SM1278) to TIA Portal V16 Programmable Logic Controller - PLC 11
U Configuring FactoryTalkView SE General Automation Chat 0
J Configuring DP/RS232 Link on Simatic S5/S7 PLC General Communications Chat 1
Similar threads
Configuring Analog I/O board and I/O packs of Mark Vie control system
Configuring SDB Utility
Configuring S7-1200 IO-Link Master Module (SM1278) to TIA Portal V16
Configuring FactoryTalkView SE
Configuring DP/RS232 Link on Simatic S5/S7 PLC

You May Also Like

Top