Control

Connecting a PM500 via a uds10 (Lantronix terminal server) to a PC...

J

Thread Starter

Joe F.

So there is a PC, which is connected to the uds10 via TCP/IP, the other side of the uds10 is connected to the PM500 via modbus (2 wire TX/RX+ and TX/RX-). I hope somebody know the good configuiration of the uds10 (for example: which firmware type (standard or modbus), adjusting...).

Thank you
Joe F.
 
You must log in or register to reply here.
Thread starter Similar threads Forum Replies Date
B How to protect Modbus TCPIP server from connecting more than Max number of connections, new connection causing dropping of old connections Modbus 1
psycho Need help connecting Omron 3G3MX2 drive to Modbus Poll Software Modbus 2
J Connecting RS485 enabled device to RS422 enabled device. Networking 3
M Connecting to Abb pm852-eth Programmable Logic Controller - PLC 5
P Generator voltage and amps increase when connecting a load Power Generation 1
Similar threads
How to protect Modbus TCPIP server from connecting more than Max number of connections, new connection causing dropping of old connections
Need help connecting Omron 3G3MX2 drive to Modbus Poll Software
Connecting RS485 enabled device to RS422 enabled device.
Connecting to Abb pm852-eth
Generator voltage and amps increase when connecting a load

You May Also Like

Top