D
Hi
We have six S7 300+2DP plc that work separately "e.g.
plc-1 and plc-2 and plc-3 and plc-4 and plc-5 and
plc-6"
each plcs work separately with its op170B and cpus aren't link together. For connecting plcs together and to three wincc station what should I do? I want to know, should I configure a new project including six simatic station 300?
Means i must create a new project for example "total" and configure six simatic station 300 according to stations that have been configured In six separate projects? and then configure all CPUs as DP-Master with bus profile "Standard". in Net pro of total project we will see all cpus that connected to profibus DP sub net. if i configure in each plc, its CPU as DP-Master with bus profile "Standard" without define new project "total" means in Netpro only one cpu appeared, will be ok? If one cpu in network go to fault, we would have fault In all cpu?
If we want to have 3 station as wincc HMI, can I use
from cp5611? do I need another software? should I define PG/PC or other station or simatic pc station for wincc station?
Best regads
soft
We have six S7 300+2DP plc that work separately "e.g.
plc-1 and plc-2 and plc-3 and plc-4 and plc-5 and
plc-6"
each plcs work separately with its op170B and cpus aren't link together. For connecting plcs together and to three wincc station what should I do? I want to know, should I configure a new project including six simatic station 300?
Means i must create a new project for example "total" and configure six simatic station 300 according to stations that have been configured In six separate projects? and then configure all CPUs as DP-Master with bus profile "Standard". in Net pro of total project we will see all cpus that connected to profibus DP sub net. if i configure in each plc, its CPU as DP-Master with bus profile "Standard" without define new project "total" means in Netpro only one cpu appeared, will be ok? If one cpu in network go to fault, we would have fault In all cpu?
If we want to have 3 station as wincc HMI, can I use
from cp5611? do I need another software? should I define PG/PC or other station or simatic pc station for wincc station?
Best regads
soft