ConneXium Ethernet Gateway TSXETG100

G

Thread Starter

gi

hello to all,

Am currently working on a BMS project where i have to make 20 sections, each with its own controller (using MODBUS RTU), communicate on the same bus (ethernet).

I would like to know the difference between Master Mode Topology and Slave Mode Topology for the TSXETG100.

Also in Slave Mode Topology why must a TSXETG100 be connected to the same ethernet network in slave mode ?

The SCADA cannot communicate with the devices on the ethernet network directly ?

Am basing myself on what i've read in the ConneXium Ethernet Gateway TSXETG100 manual.

for a picture of the MODBUS network please mail me: girishraj84 [at] yahoo.com

Regards
 
Top