Control

Converter from BSAP to Modbus/CAN

  • Thread starter Tecnicas y Tecnicas Industriales Ltda
  • Start date
T

Thread Starter

Tecnicas y Tecnicas Industriales Ltda

Does someone know where I can find a converter from BSAP protocol to modbus or CAN.

Gustavo
 
F

Félix Blanco

Gustavo,

If you are using a Bristol Babcok network 3000, with DPC-3330 or DPC-3335, you can program one serial port of the CFE (node level 0 of the network), or the dpc you need data, to be a modbus slave. This protocal is build-in the CPU of each DPC. Hope this help..

Félix Blanco
 
You must log in or register to reply here.
Thread starter Similar threads Forum Replies Date
M Modbus Bacnet converter Modbus 25
C GE 5001 torque converter not turning turbina shaft Power Generation 6
S Need Converter (24 V AC to 12 V DC, approx. load 60 watt) Automobile application Electrical Engineering 3
rubelCPGCBL I to P converter convert 4-20mA signal to 3-15 psi signal then, this 3-15psi signal goes to actuator to actuate the control valve position. Instrumentation & Measurement 1
N Combining RS485 with Wifi TCP/IP. Buy converter or ??? Modbus 5
Similar threads
Modbus Bacnet converter
GE 5001 torque converter not turning turbina shaft
Need Converter (24 V AC to 12 V DC, approx. load 60 watt) Automobile application
I to P converter convert 4-20mA signal to 3-15 psi signal then, this 3-15psi signal goes to actuator to actuate the control valve position.
Combining RS485 with Wifi TCP/IP. Buy converter or ???

You May Also Like

Top