cybelec control problem

  • Thread starter krzysztof golanski
  • Start date
K

Thread Starter

krzysztof golanski

I have the problem concerning the pressbrake machine AMADA with CYBELEC control (CYBELEC, type cnc DNC74IT, serial:10060; SOFT PDXFCA N2XFE)
Right after turning on the machine on the screen appears an announcement Voltage and it is impossible to curry out next operations on the machine. What that’s mean Voltage?

So i would like to ask for the help to solve this problem.

Thank you in advance.
Best regards
Krzysztof Golanski, Poland
e-mail: [email protected]
 
in answer to your ???? for message voltage, the message is indicating some problem exists with the power supply +15v or -15v to the dnc, however in many cases it is possible in the machine parameters to turn off this 'check' of the power supply, this would then allow you to carry out any required repair, adjustment etc.
if more info is required please contact me directly ([email protected])
best regards Bob.
 
Top