We are looking for standard implementation of DNP 3 (slave) protocol in PCM module of GE-Fanuc 90-70 PLCs. Can we get a good reference which is immediately available as commerically off the shelf product. The protocol driver shall take care of total I/O of about 1024 or even higher.

 

u might want to check "www.controlprotocols.com":http://www.controlprotocols.com who have off-the shelf DNP3 Level 1/2 support products available for both 90-30 and 90-70 series PCM's.

--------------------------------------
Prasanth Gopalakrishnan
Managing Director
Kalki Communication Technologies Private Limited,
2nd Floor, #147, 5th Main Road, HSR Sector 7
Bangalore 560034, Karnataka, India
Phone(O): 91-80-572 1263/4
Phone(H): 91-80-572 0353
Fax: 91-80-5721264, 1 646 365 7718
E-mail: [email protected]
Web: www.kalkitech.com

 

We have used many of Control Protocols International's products with excellent results. They have been responsive to questions and very helpful with initial setups. They are the only ones I know of who have a DNP option for the GE Fanuc PLC's.